Rear 9 mm brake pipe kit (6 pieces)

This set of 6 rear brake pipes 09 carries pressurised brake fluid through the various sections of the rear hydraulic braking circuit. When the brake pedal is pressed, the pressure generated by the master cylinder flows through the pipes to the rear braking components, allowing them to operate.

These six pipes are positioned within the vehicle's rear braking circuit and provide the various hydraulic connections required to the rear wheels. Each pipe must be installed in its correct position, following the intended routing of the braking circuit.

During installation, the pipes must be correctly positioned with the appropriate seals and securely fastened to prevent rubbing, pinching or stress that could damage them. The unions are fitted using a 9 mm spanner. The tightness and sealing of each union must be checked before putting the braking circuit into service.

Technical specifications :
. Material : annealed copper
. Number of pipes : 6
. Pipe diameter : 4.5 mm
. Union : 9 mm, thread pitch : 1.25
. Compatible fluids : Lockheed or DOT 4
. Position : rear braking circuit
. Tool for unions : 9 mm spanner
. 2CV compatibility : models first registered between May 1967 and 1973
. Méhari compatibility : models first registered between 1968 and 1973

Vehicles :
. 2CV
. Méhari
. Dyane