Rear banjo brake connector (lateral part, length 2000mm)

This rear lateral banjo brake pipe carries pressurised brake fluid to the rear braking circuit. When the brake pedal is pressed. hydraulic pressure flows through the pipe to supply the rear braking components and allow them to operate.

This pipe is positioned along the side of the vehicle and runs towards the rear braking circuit. It connects to the rear brake distribution T-piece, which distributes the brake fluid to the relevant rear braking components.

During installation, the pipe must be correctly positioned with suitable seals to ensure leak-tight connections. It must also be installed without kinks, rubbing or excessive stress that could cause damage. The hydraulic circuit must be checked for leaks before the braking system is put back into service.

Technical installation diagram for banjo brake pipe before 09/1963 : Banjo brake pipe – before 09/1963.

Technical specifications :
• Material : copper-nickel alloy
• Pipe diameter : 6.35 mm
• Length : 2,000 mm
• Connection type : banjo
• Compatible brake fluids : Lockheed or DOT 4
• Position : lateral section of the rear braking circuit
• Function : connection to the rear brake distribution T-piece
• Compatibility : 2CV from June 1952 to July 1964

Vehicles :
• 2CV